会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 1. 发明授权
    • Electronic circuit with a regulated power supply circuit
    • 具有稳压电源电路的电子电路
    • US08659344B2
    • 2014-02-25
    • US13144337
    • 2010-01-13
    • Martin WagnerHenk BoezenClemens Gerhardus Johannes de Haas
    • Martin WagnerHenk BoezenClemens Gerhardus Johannes de Haas
    • H03K17/16
    • G05F1/565
    • A power supply regulator circuit uses a feedback loop to control current through a first output transistor from a power supply input to a regulated power supply output. The first output transistor is included in an integrated circuit. In order to avoid heating of the integrated circuit in excess of an acceptable level due to permanent supply of a high current through the first transistor, current through a second output transistor in parallel with the first transistor, but outside the integrated circuit is raised when it is detected that the current through the first output transistor exceeds a threshold level. The second output transistor outside the integrated circuit serves to take over supply of a part of the power supply current from first output transistor inside integrated circuit, when long term supply of that part from first output transistor would lead to undesirable heating of the integrated circuit. During a limited time interval a first transistor current above the threshold level is acceptable. During this time interval the current through the second output transistor is raised slowly in order to avoid unpredictable stability problems and the generation of excessive power supply noise.
    • 电源调节器电路使用反馈回路来控制从电源输入到稳压电源输出的第一输出晶体管的电流。 第一输出晶体管包含在集成电路中。 为了避免由于通过第一晶体管的高电流的永久供应而使集成电路的加热超过可接受的电平,通过与第一晶体管并联的第二输出晶体管,但是当集成电路的外部集成 检测到通过第一输出晶体管的电流超过阈值电平。 集成电路外部的第二输出晶体管用于从集成电路内部的第一输出晶体管接收一部分电源电流,当来自第一输出晶体管的该部分的长期供应将导致集成电路的不期望的加热时。 在有限的时间间隔内,高于阈值电平的第一晶体管电流是可接受的。 在该时间间隔期间,缓慢升高通过第二输出晶体管的电流,以避免不可预测的稳定性问题和产生过大的电源噪声。
    • 3. 发明授权
    • Line driver with current source output and high immunity to RF signals
    • 具有电流源输出的线路驱动器和对RF信号的高抗扰度
    • US06949963B2
    • 2005-09-27
    • US10095348
    • 2002-03-11
    • Clemens Gerhardus Johannes De HaasHendrik BoezenAloysius Johannes Maria BoomkampGerrit Jan BollenAbraham Klaas Van Den HeuvelRuurd Anne Visser
    • Clemens Gerhardus Johannes De HaasHendrik BoezenAloysius Johannes Maria BoomkampGerrit Jan BollenAbraham Klaas Van Den HeuvelRuurd Anne Visser
    • H03K17/16H03K17/687H03K19/0175H04L25/02H03K3/00
    • H04L25/028
    • Line driver for a LIN-bus. The line driver has a current source output transistor (T1) for pulling down the LIN-bus wire (LB) to ground (GND). The LIN-bus wire (LB) is connected to a positive supply voltage (VBAT) through a pull-up resistor (R1). The output transistor (T1) is driven by a driver stage (DRV) in response to an input current (J1) at an input node (X). The driver stage has a further resistor (R2) connected between the gate of the output transistor (T1) and a reference terminal (GND), a reference transistor (T2) which has its source connected to the reference terminal (GND) and its drain coupled to the input node (X); the gates of the output transistor (T1) and the reference transistor (T2) are connected to an output (DAO1) of a differential amplifier (DA1) which has an inverting input (DAN1) coupled to a bias voltage source (E2) and a non-inverting input (DAP1) coupled to the input node (X). The further resistor (R2) stage provides a low-impedance path to ground for RF disturbances reaching the gate of the output transistor (T1) through the drain-gate capacitance of the output transistor (T1) and prevents these disturbances from penetrating the driver stage.
    • 用于LIN总线的线路驱动器。 线路驱动器具有用于将LIN总线(LB)拉到地(GND)的电流源输出晶体管(T 1)。 LIN总线(LB)通过上拉电阻(R 1)连接到正电源电压(VBAT)。 响应于输入节点(X)处的输入电流(J 1),输出晶体管(T 1)由驱动级(DRV)驱动。 驱动级具有连接在输出晶体管(T 1)的栅极和参考端子(GND)之间的另一个电阻器(R 2),其源极连接到参考端子(GND)的参考晶体管(T 2) 并且其漏极耦合到输入节点(X); 输出晶体管(T 1)和参考晶体管(T 2)的栅极连接到差分放大器(DA 1)的输出(DAO 1),差分放大器(DA 1)具有耦合到偏置电压源 (E 2)和耦合到输入节点(X)的非反相输入(DAP 1)。 另外的电阻器(R 2)级通过输出晶体管(T 1)的漏极 - 栅极电容为RF输入端到达输出晶体管(T 1)的栅极提供了一个低阻抗路径,并防止这些干扰穿透 司机舞台。