会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 81. 发明授权
    • Defrost bimetal for interrupting time cycle ice maker during defrost-single timer
    • 在DEFROST-SINGLE TIMER期间中断时间周期制冰机的DEFROST BIMETAL
    • US3659430A
    • 1972-05-02
    • US3659430D
    • 1970-06-18
    • WHIRLPOOL CO
    • NICHOLS DUANE CLINSTROMBERG WILLIAM J
    • F25C1/24F25D21/00G04F3/06F25C1/10
    • G04F3/06F25C1/24F25D21/002
    • A refrigerator-freezer apparatus normally operating through freezing and defrosting portions of an operating cycle. The apparatus includes an ice maker and a timer motor that preferably also comprises the drive motor of the ice maker. A single temperature responsive switch in heat exchange relationship with the evaporator of the apparatus opens at an above freezing temperature condition of the evaporator so as to terminate operation of the defrost heater during the defrosting portion of the operation cycle and prevents cycling of the ice maker in the event of a high temperature condition, such as during start-up of the apparatus, to prevent the ice maker dumping unfrozen water into the freezer compartment of the apparatus.
    • 通常通过操作循环的冷冻和除霜部分操作的冰箱 - 冷冻设备。 该装置包括制冰机和定时器马达,其优选地还包括制冰机的驱动马达。 与设备的蒸发器的热交换关系的单个温度响应开关在蒸发器的上述冷冻温度条件下打开,以在操作循环的除霜部分期间终止除霜加热器的操作,并防止制冰机的循环 诸如在设备启动期间的高温状况的事件,以防止制冰机将未冷冻的水倾倒到设备的冷冻室中。
    • 82. 发明授权
    • Differential-motion timer
    • 差分运动定时器
    • US3654408A
    • 1972-04-04
    • US3654408D
    • 1970-04-30
    • JAMES M MEEK
    • MEEK JAMES M
    • G04F3/06H01H43/18
    • G04F3/06
    • A differential-motion timer. Reciprocating motion of a predetermined frequency and angular displacement is converted into unidirectional rotary motion by means of at least two ratchet wheels coaxially aligned and independently free-wheeling and each having a different number of notches. Each of the ratchet wheels is driven by a ratchet drive which is connected to the reciprocating element. Accordingly, each ratchet wheel can convert reciprocating motion to unidirectional rotary motion, the speed of the rotary motion being, on the average, proportional to the driver frequency. Since each of the ratchet wheels has a different number of notches, it follows that each of the wheels will be driven at a slightly different speed by the single ratchet driver. This difference speed is the timing motion and the relative angular positions of the wheels correspond to the elapsed time. A switch is actuated whenever certain preselected corresponding points on each of the ratchet wheels arrive at predetermined positions.
    • 差分运动定时器。 预定频率和角位移的往复运动通过至少两个同轴对准且独立地独轮式并且每个具有不同数量的凹口的棘轮转换成单向旋转运动。 每个棘轮由连接到往复元件的棘轮驱动器驱动。 因此,每个棘轮可以将往复运动转换为单向旋转运动,平均而言,旋转运动的速度与驾驶员频率成比例。 由于每个棘轮具有不同数量的凹口,因此每个轮将以单个棘轮驱动器以略微不同的速度被驱动。 该差速是时间运动,并且车轮的相对角位置对应于经过的时间。 每个棘轮上的某些预先选定的对应点到达预定位置时,启动开关。