会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 22. 发明授权
    • Method and circuitry for battery protection
    • US09768608B2
    • 2017-09-19
    • US14372185
    • 2012-02-14
    • Timo ToivolaJuhani Kari
    • Timo ToivolaJuhani Kari
    • H02M1/32H02M1/36H02H3/24G06F1/26H02J7/00
    • H02H3/243G06F1/26H02J7/0029H02J2007/004
    • There is disclosed a method comprising providing a first signal to an apparatus comprising a protection circuit and an output for providing electric power. The protection circuit comprises at least an overdischarge detection element and a discharging control output. The first signal is used to change a voltage level at an input of the overdischarge detection element of the protection circuit. The change of the voltage level at the input of overdischarge detection element is detected, and a second signal is provided at the discharging control output to switch off the output of the apparatus. There is also disclosed an apparatus comprising a protection circuit comprising at least an overdischarge detection element and a discharging control output. The apparatus also comprises an output for providing electric power; the protection circuit; and a first signal input adapted to receive a first signal to change a voltage level at an input of the overdischarge detection element of the protection circuit. The overdischarge detection element is configured for detecting the change of the voltage level at the input of the overdischarge detection element, and for providing a second signal at the discharging control output to switch off the output of the apparatus.
    • 24. 发明申请
    • DETECTING FAULTS IN ELECTRICITY GRIDS
    • 检测电网中的故障
    • US20160248246A1
    • 2016-08-25
    • US15026181
    • 2014-09-17
    • VESTAS WIND SYSTEMS A/S
    • Lars HELLERemus TEODORESCU
    • H02H7/26H02M5/458F03D9/00H02H3/08H02H3/24
    • H02H7/26F03D7/0284F03D9/255F05B2260/80H02H3/083H02H3/24H02M5/458Y02E10/723
    • A wind turbine generator 1 is connected to a section 2 of an electricity grid 3 via a converter 4, which converts the ac output power from the generator into three-phase electric power at the voltage and frequency of the grid 3. The converter 4 comprises silicon carbide transistors which act as ON-OFF switches which are controlled so as to create a voltage profile which is the same as that of the grid voltage. Each grid section 2, 2′ has a respective circuit breaker 10, 10′ which disconnects the associated section from the remainder of the grid 3 in the event of an abnormally high current. The converter 2 includes a fault detector 11 arranged to detect grid faults, such as an abnormally low voltage level which, in response, generates an alarm signal which causes a high-level transient current to be supplied to the grid 3 sufficient to trip the circuit breaker 10′ so as to disconnect the faulty section of the grid. By using silicon carbide transistors, which can withstand high operating temperatures, a higher-level current can be generated than would be the case with converters using conventional silicon transistors.
    • 风力发电机1经由转换器4连接到电网3的部分2,转换器4将来自发电机的交流输出功率以电网3的电压和频率转换成三相电力。转换器4包括 用作开关开关的碳化硅晶体管,其被控制以产生与电网电压相同的电压分布。 每个电网部分2,2'都有一个相应的断路器10,10',它们在异常高电流的情况下将相关部分与电网3的其余部分断开。 转换器2包括故障检测器11,其被布置成检测电网故障,例如异常低的电压电平,其响应地产生报警信号,其引起高电平瞬态电流被提供给电网3,足以使电路跳闸 断路器10',以便断开电网的故障部分。 通过使用可承受高工作温度的碳化硅晶体管,可以产生比使用常规硅晶体管的转换器情况更高的电流。
    • 26. 发明授权
    • Controller for a brushless motor
    • 无刷电机控制器
    • US09407085B2
    • 2016-08-02
    • US14321437
    • 2014-07-01
    • Dyson Technology Limited
    • Libo ZhengYongji ZhouTuncay Celik
    • H02H3/24H02H7/08H02P6/08H02M1/32H02M1/36H02M7/5387
    • H02H7/08H02M1/32H02M1/36H02M7/5387H02P6/085H02P29/0241
    • A controller for a brushless motor that is configured to operate in normal mode or under-voltage mode. When operating in normal mode, the controller generates control signals for exciting a winding of the motor, monitors the magnitude of an input voltage, and switches to under-voltage mode in the event that the input voltage drops below an under-voltage threshold. When operating in under-voltage mode, the controller suspends excitation of the winding, monitors the magnitude of the input voltage, monitors the magnitude of a supply voltage used to power the controller, switches to normal mode in the event that the input voltage exceeds a restart threshold, and resets itself in the event that the supply voltage drops below a brown-out threshold.
    • 用于无刷电动机的控制器,其被配置为在正常模式或欠压模式下操作。 当在正常模式下工作时,控制器产生用于激励电动机的绕组的控制信号,监视输入电压的大小,并且在输入电压降到低于欠电压阈值的情况下切换到欠电压模式。 当在欠电压模式下工作时,控制器暂停绕组的激励,监视输入电压的大小,监视用于为控制器供电的电源电压的大小,在输入电压超过 重新启动阈值,并在电源电压低于欠压阈值的情况下自行复位。
    • 28. 发明授权
    • Wide input voltage range power supply circuit
    • 宽输入电压范围电源电路
    • US09252652B2
    • 2016-02-02
    • US13313952
    • 2011-12-07
    • Michael Gasperi
    • Michael Gasperi
    • G05F1/00G05F1/569G05F1/571H02H3/24H02M1/10
    • H02M1/10H02M7/2176
    • A wide input voltage power supply circuit for a load includes a first stage and a second stage. The first stage includes a linear regulator circuit configured to maintain an output voltage at a predetermined output voltage level. The linear regulator includes an input for shutting the linear regulator off when an input voltage exceeds a predetermined shut off threshold. The second stage includes a high voltage detection circuit coupled to the input of the linear regulator. The high voltage detection circuit is configured to detect the level of the input voltage and to shut the linear regulator off when the input voltage exceeds the predetermined shut off threshold. An under voltage lockout circuit may be included, the under voltage lockout circuit configured to set a minimum turn-on voltage for the load.
    • 用于负载的宽输入电压电源电路包括第一级和第二级。 第一级包括线性稳压器电路,其被配置为将输出电压保持在预定的输出电压电平。 线性调节器包括用于当输入电压超过预定关闭阈值时关闭线性调节器的输入。 第二级包括耦合到线性调节器的输入的高电压检测电路。 高电压检测电路被配置为检测输入电压的电平并且当输入电压超过预定的关断阈值时关闭线性调节器。 可以包括欠压锁定电路,欠压锁定电路被配置为设置负载的最小导通电压。
    • 29. 发明申请
    • Isolation Device And System
    • 隔离装置和系统
    • US20150323588A1
    • 2015-11-12
    • US14273915
    • 2014-05-09
    • Avago Technologies General IP (Singapore) Pte. Ltd.
    • Jia PengFun Kok ChowChee Heng WongKwee Chong Chang
    • G01R31/28H02H3/24H02M3/335H05B33/08
    • H02M3/33523G01R31/2836H02H3/24H02M3/33507H02M2001/0003H05B33/0815H05B37/00
    • An isolation device having first and second semiconductor is disclosed. The first semiconductor die may be adapted to transmit a first signal to the second semiconductor die that is electrically isolated. The first semiconductor die may have a transmitter coupled to a modulator that modulates the first signal. The second semiconductor die may have a receiver having a counter and a control circuit. The control circuit may be adapted to determine an indication of the first signal by using the counter. In addition, an isolation system and a DC-DC feedback regulation control system having such control circuit are disclosed. Likewise, a method for conveying a first signal across an isolation barrier is disclosed. The method may comprise counting a received signal based on internal clock and determining an indication of the first signal from the counter's count value.
    • 公开了一种具有第一和第二半导体的隔离装置。 第一半导体管芯可以适于将第一信号传输到电隔离的第二半导体管芯。 第一半导体管芯可以具有耦合到调制器的调制器的发射器,该调制器调制第一信号。 第二半导体管芯可以具有具有计数器和控制电路的接收器。 控制电路可以适于通过使用计数器来确定第一信号的指示。 此外,公开了具有这种控制电路的隔离系统和DC-DC反馈调节控制系统。 同样地,公开了一种跨越隔离屏障传送第一信号的方法。 该方法可以包括基于内部时钟对接收信号进行计数,并根据计数器的计数值确定第一信号的指示。
    • 30. 发明授权
    • Feedback protection from adjacent terminal shorts
    • 相邻端子短路的反馈保护
    • US09036310B2
    • 2015-05-19
    • US14012897
    • 2013-08-28
    • Power Integrations, Inc.
    • Daniel C. Prescott
    • H02H3/24H02H9/04
    • H02H9/045H02M1/32
    • This relates to detecting unwanted couplings between a protected terminal and an adjacent terminal of an IC controller of a power supply. The voltages across adjacent terminals are monitored. If the voltage difference between the terminals falls below a minimum threshold for greater than a first duration of time, an internal current source injects current into one of the terminals. If, within a second duration of time, the injected current pulls the voltage of the injected terminal to a voltage that causes the voltage difference between the terminals to be above the minimum threshold, it may be determined that a transient fault has occurred and been cleared or falsely detected. If, however, the injected current does not pull the voltage of the injected terminal to a voltage that causes the voltage between the adjacent terminals to be above the minimum threshold, the fault condition is confirmed and switching is disabled.
    • 这涉及检测受保护终端和电源的IC控制器的相邻终端之间的不期望的耦合。 监控相邻端子间的电压。 如果端子之间的电压差低于最小阈值大于第一持续时间,则内部电流源将电流注入到一个端子中。 如果在第二持续时间内,注入的电流将注入的端子的电压拉到导致端子之间的电压差高于最小阈值的电压,则可以确定发生了瞬态故障并被清除 或虚假检测。 然而,如果注入电流没有将注入的端子的电压拉到导致相邻端子之间的电压达到最小阈值的电压,则确认故障状态并禁用开关。