会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 5. 发明授权
    • Contactless sensor driven by single power supply
    • 非接触传感器由单电源驱动
    • US5654630A
    • 1997-08-05
    • US644577
    • 1996-05-10
    • Kenichi ShimoyamaYouichi AraiTsutomu Saigo
    • Kenichi ShimoyamaYouichi AraiTsutomu Saigo
    • G01R1/07G01R15/20G01R19/00
    • G01R1/07G01R15/202
    • A sensor contactlessly driven by a single power supply is disclosed. A current flows in a resistor R.sub.L through the secondary winding of a coil in the direction corresponding to the direction of magnetic fluxes generated in the coil in accordance with discharge or charge mode of a main battery. The input terminal of a voltage follower is connected to the voltage-dividing point of a series circuit including resistors R.sub.1 and R.sub.2 and a reference voltage control circuit. The reference voltage control circuit changes the input voltage of the voltage follower in accordance with the direction of the current flowing in the resistor R.sub.L. It follows therefore that the measurement range is switched in accordance with discharge or charge mode of the main battery, with the result that the overall measurement range can be widened in spite of the fact that only a single power supply +Vcc is used.
    • 公开了由单个电源非接触驱动的传感器。 A电流根据主电池的放电或充电模式沿与线圈中产生的磁通方向相对应的方向通过线圈的次级绕组流过电阻器RL。 电压跟随器的输入端子连接到包括电阻器R1和R2以及参考电压控制电路的串联电路的分压点。 参考电压控制电路根据在电阻器RL中流动的电流的方向改变电压跟随器的输入电压。 因此,根据主电池的放电或充电模式来切换测量范围,结果是尽管仅使用单个电源+ Vcc,总体测量范围可以扩大。
    • 9. 发明授权
    • Battery capacity calculating method and device therefor
    • 电池容量计算方法及其装置
    • US06661231B1
    • 2003-12-09
    • US09856467
    • 2001-10-09
    • Youichi AraiTsutomu SaigoHideaki Kamohara
    • Youichi AraiTsutomu SaigoHideaki Kamohara
    • G01N27416
    • G01R31/3624G01R31/3648G01R31/3675
    • A method and apparatus are provided, by which a state of charge of a battery is accurately computed without being influenced by the polarization effect. An estimated voltage of the battery 13 in a constant load discharge with a predetermined large current value is estimated from a voltage-current characteristic when the discharge current of the constant load discharging process by the battery 13 that is in an equilibrium state is decreasing from the predetermined large current value corresponding to a maximum supplying electric power to the load. A difference between the estimated voltage and an open circuit voltage, which estimates the estimated voltage and is a terminal voltage of the battery 13 that is in an equilibrium state before the start of the constant load discharge by using the predetermined large current value, is calculated. Then, the difference is memorized by first memory means 27 for memorizing a residual voltage drop defining as the residual voltage drop due to a residual polarization at the end of the discharging process of the battery 13. The residual voltage drop memorized by the first memory means 27 is added to the estimated voltage of the battery 13, thereby a present charging capacity of the battery 13 is computed.
    • 提供了一种方法和装置,通过该方法和装置可以精确地计算电池的充电状态而不受偏振效应的影响。 当处于平衡状态的电池13的恒定负载放电过程的放电电流从电池电流特性减小时,从电压 - 电流特性估计具有预定大电流值的恒定负载放电中的电池13的估计电压 预定的大电流值对应于向负载提供电力的最大值。 计算估计电压和开路电压之间的差异,该电压估算出通过使用预定大电流值在恒定负载放电开始之前处于平衡状态的电池13的估计电压并且是其终端电压 。 然后,差值由第一存储装置27存储,用于存储由于在电池13的放电过程结束时由于残余极化而定义为残余电压降的残余电压降。由第一存储装置存储的剩余电压降 27被添加到电池13的估计电压,由此计算电池13的当前充电容量。
    • 10. 发明授权
    • Residual capacity measurement system for battery
    • 电池剩余容量测量系统
    • US06310462B1
    • 2001-10-30
    • US09604059
    • 2000-06-26
    • Youichi AraiMakoto Ishigami
    • Youichi AraiMakoto Ishigami
    • H01M1046
    • G01R31/3624G01R31/006G01R31/3648G01R31/3693
    • After an initial capacity setter (13) sets the initial residual capacity immediately after the application of power as 100%, a full-charge voltage corrector (14) sets the full-charge voltage as the estimation voltage Vn0 of a battery (3) immediately after a load change, this full-charge voltage Vno being used to determine the residual capacity SOC immediately after the change. After charging is interrupted midway, if the load is changed, a full-charge voltage estimator estimates the full-charge voltage responsive to the estimation voltage immediately after the load change, this estimated full-charge voltage being used to determine the residual capacity.
    • 在初始容量设定器(13)将施加电力之后的初始剩余容量设置为100%之后,全充电电压校正器(14)将充满电压设置为电池(3)的估计电压Vn0 在负载变化之后,该全充电电压Vno用于确定变更后的剩余容量SOC。 中途充电中断后,如果负载发生变化,则满充电压估计器将根据负载变化后的估计电压来估计满充电压,该估计的全充电电压用于确定剩余容量。