会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 3. 发明申请
    • CONTROL DEVICE OF A SWITCHING POWER SUPPLY
    • 开关电源的控制装置
    • US20130194842A1
    • 2013-08-01
    • US13749539
    • 2013-01-24
    • DORA S.P.A.STMicroelectronics S.r.l.
    • Alberto BiancoClaudio Adragna
    • H02M3/156
    • H02M3/156H02M1/4225H02M3/157Y02B70/126
    • A control device controls a switching converter. The converter has an input alternating supply voltage, a regulated direct voltage on the output terminal, and a switch connected to an inductor. The control device controls the closing and opening time period of said switch for each cycle and receives a first input signal representative of the current flowing through one element of the converter. The control device comprises a counter configured to count a time period, a comparator configured to compare said first input signal with a second signal, digital control block configured to control the closing and opening of said switch and to activate said counter to start the counting of said time period when the said first input signal crosses said second signal, with said switch being closed. The digital control block is configured to open the switch when the counter finishes the counting of said time period.
    • 控制装置控制开关转换器。 转换器具有输入交流电源电压,输出端子上的稳压直流电压和连接到电感器的开关。 控制装置控制每个周期的所述开关的闭合和打开时间周期,并且接收表示流过转换器的一个元件的电流的第一输入信号。 控制装置包括配置成对时间段进行计数的计数器,被配置为将所述第一输入信号与第二信号进行比较的比较器,被配置为控制所述开关的关闭和打开的数字控制块,并激活所述计数器以开始计数 所述时间段,当所述第一输入信号与所述第二信号相交时,所述开关闭合。 数字控制块被配置为当计数器完成所述时间段的计数时打开开关。
    • 4. 发明授权
    • Control device of a switching power supply
    • 开关电源的控制装置
    • US09154030B2
    • 2015-10-06
    • US13749539
    • 2013-01-24
    • DORA S.p.A.STMicroelectronics S.r.l.
    • Alberto BiancoClaudio Adragna
    • H02M3/156H02M1/42H02M3/157
    • H02M3/156H02M1/4225H02M3/157Y02B70/126
    • A control device controls a switching converter. The converter has an input alternating supply voltage, a regulated direct voltage on the output terminal, and a switch connected to an inductor. The control device controls the closing and opening time period of said switch for each cycle and receives a first input signal representative of the current flowing through one element of the converter. The control device comprises a counter configured to count a time period, a comparator configured to compare said first input signal with a second signal, digital control block configured to control the closing and opening of said switch and to activate said counter to start the counting of said time period when the said first input signal crosses said second signal, with said switch being closed. The digital control block is configured to open the switch when the counter finishes the counting of said time period.
    • 控制装置控制开关转换器。 转换器具有输入交流电源电压,输出端子上的稳压直流电压和连接到电感器的开关。 控制装置控制每个周期的所述开关的闭合和打开时间周期,并且接收表示流过转换器的一个元件的电流的第一输入信号。 控制装置包括配置成对时间段进行计数的计数器,被配置为将所述第一输入信号与第二信号进行比较的比较器,被配置为控制所述开关的关闭和打开的数字控制块,并激活所述计数器以开始计数 所述时间段,当所述第一输入信号与所述第二信号相交时,所述开关闭合。 数字控制块被配置为当计数器完成所述时间段的计数时打开开关。
    • 7. 发明申请
    • CONTROL DEVICE FOR RECTIFIERS OF SWITCHING CONVERTERS
    • 开关变流器整流器的控制装置
    • US20150049522A1
    • 2015-02-19
    • US14459159
    • 2014-08-13
    • DORA S.p.A.
    • Alberto IorioMaurizio ForestaAlberto Bianco
    • H02M3/335
    • H02M3/33576H02M3/1588H02M3/33592H02M2001/0058Y02B70/1425Y02B70/1433Y02B70/1466Y02B70/1475Y02B70/1491
    • A control device detects zero crossings of a current through a rectifier transistor during plural cycles; generates a turn-on signal of the transistor and inserts a turn-on delay equal to a fixed first quantity from the start time of for each cycle. The control device starts counting consecutive cycles after inserting the turn-on delay; detects whether a zero crossing of the current through the transistor after turning on said transistor has occurred; if no zero crossing is detected before counting a number N of consecutive cycles, decreases the turn-on delay by a fixed second quantity for the next cycle; if a zero crossing is detected, maintains turned on the transistor; if the turn-on delay is smaller than first quantity, increases the turn-on delay o for the next switching cycle; and if the turn-on delay is equal to the first quantity, maintains the turn-on delay for the next switching cycle.
    • 控制装置在多个周期期间检测通过整流器晶体管的电流的零交叉; 产生晶体管的导通信号,并从每个周期的开始时间插入等于固定的第一量的导通延迟。 控制装置在插入接通延迟后开始连续循环计数; 检测在导通所述晶体管之后是否发生通过所述晶体管的电流的过零点; 如果在对连续循环数N进行计数之前没有检测到零交叉,则在下一个周期将导通延迟减少固定的第二数量; 如果检测到零交叉,维持导通晶体管; 如果导通延迟小于第一量,则增加下一个开关周期的导通延迟o; 并且如果导通延迟等于第一数量,则维持下一个开关周期的导通延迟。
    • 8. 发明申请
    • TRANSITION MODE PFC POWER CONVERTER ADAPTED TO SWITCH FROM DCM TO CCM UNDER HIGH LOAD AND CONTROL METHOD
    • 过渡模式PFC功率转换器适用于从高负载和控制方式从DCM切换到CCM
    • US20150002109A1
    • 2015-01-01
    • US14321600
    • 2014-07-01
    • DORA S.p.A.
    • Alberto Bianco
    • H02M1/42
    • H02M1/4225H02M1/4208Y02B70/126
    • A transition mode power factor correction converter comprising a boost inductor, a switch, a diode, and output tank capacitor, has circuit means of limitation of the off-time interval of the switch to a fraction of the off-time interval, “complementary” to the on-time interval that is normally controlled for regulating the output voltage, during part of a cycle of a rectified sinusoidal voltage waveform input to the converter, when the current flowing in the inductor reaches a maximum threshold, causing the mode of operation of the device to switch from transition mode to continuous current mode for a middle phase angle region of a rectified sinusoidal input voltage waveform, under high load conditions, defined by said maximum current threshold. Current peaks amplitude and ripple are effectively reduced for same output power.
    • 包括升压电感器,开关,二极管和输出电容器的过渡模式功率因数校正转换器具有将开关的截止时间间隔限制到关断时间间隔的一部分的电路装置,“互补” 在输入到转换器的整流正弦波电压波形的一部分周期期间,当电流中流过电感器的电流达到最大阈值时,通常被控制用于调节输出电压的导通时间间隔,导致操作模式 在由最大电流阈值定义的高负载条件下,整流正弦输入电压波形的中间相位角的转换模式切换到连续电流模式。 对于相同的输出功率,电流峰值幅度和纹波有效降低。
    • 9. 发明授权
    • Transition mode PFC power converter adapted to switch from DCM to CCM under high load and control method
    • 转换模式PFC功率转换器适用于在高负载和控制方式下从DCM切换到CCM
    • US09219408B2
    • 2015-12-22
    • US14321600
    • 2014-07-01
    • DORA S.p.A.
    • Alberto Bianco
    • H02M3/156H02M1/42
    • H02M1/4225H02M1/4208Y02B70/126
    • A transition mode power factor correction converter comprising a boost inductor, a switch, a diode, and output tank capacitor, has circuit means of limitation of the off-time interval of the switch to a fraction of the off-time interval, “complementary” to the on-time interval that is normally controlled for regulating the output voltage, during part of a cycle of a rectified sinusoidal voltage waveform input to the converter, when the current flowing in the inductor reaches a maximum threshold, causing the mode of operation of the device to switch from transition mode to continuous current mode for a middle phase angle region of a rectified sinusoidal input voltage waveform, under high load conditions, defined by said maximum current threshold. Current peaks amplitude and ripple are effectively reduced for same output power.
    • 包括升压电感器,开关,二极管和输出电容器的过渡模式功率因数校正转换器具有将开关的截止时间间隔限制到关断时间间隔的一部分的电路装置,“互补” 在输入到转换器的整流正弦波电压波形的一部分周期期间,当电流中流过电感器的电流达到最大阈值时,通常被控制用于调节输出电压的导通时间间隔,导致操作模式 在由最大电流阈值定义的高负载条件下,整流正弦输入电压波形的中间相位角的转换模式切换到连续电流模式。 对于相同的输出功率,电流峰值幅度和纹波有效降低。
    • 10. 发明授权
    • Control circuit with hysteresis for a switching voltage regulator and related control method
    • 具有开关稳压器滞回的控制电路及相关控制方法
    • US09356511B2
    • 2016-05-31
    • US13871809
    • 2013-04-26
    • DORA S.p.A.
    • Alberto Bianco
    • H02M3/157H02M3/156H02M1/00
    • H02M3/158H02M1/08H02M3/1563H02M3/157H02M2001/0025
    • A control circuit for a switching voltage regulator is configured to receive an error signal representative of a regulator output voltage in relation to a nominal output voltage, and includes a set/reset flip-flop, a hysteresis comparator and a logic circuit. The flip-flop is configured to produce a switching control signal according to logic values at its set and reset terminals. The comparator is configured to produce a set signal at the set terminal when an error signal drops below a first value, and a reset signal when the error signal rises above a second value. The logic circuit is configured to prevent transmission of the reset signal to the reset terminal during a selected minimum time period and to thereafter enable transmission of the reset signal, and further, to produce an alternate reset signal at the reset terminal at the end of the selected maximum time period.
    • 用于开关稳压器的控制电路被配置为接收代表与额定输出电压相关的调节器输出电压的误差信号,并且包括设置/复位触发器,迟滞比较器和逻辑电路。 触发器被配置为根据其设置和复位端子处的逻辑值产生开关控制信号。 比较器被配置为当误差信号低于第一值时在设定端产生设置信号,当误差信号上升到第二值以上时,产生复位信号。 逻辑电路被配置为在所选择的最小时间段期间防止复位信号传输到复位端,并且此后能够传输复位信号,并且进一步在复位端产生替代复位信号 选定的最大时间段。